Manualshelf

HP 10500 Switch Series - HP 10500-CMW710-R2105-B Release Notes

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve 8116fl Redundant Switch Fabric Module
41424344454647484950
26
Download successfully!
31911808 bytes downloaded!
Image file 10500-CMW710-BOOT-E2102.bin is self-decompressing....
Input the file name: 10500-CMW710-BOOT-E2102.bin
Save file ...........................................Done
===========================<Enter Serial SubMenu>===========================
|Note:the operating device is flash |
|<1> Download Image Program To SDRAM And Run |
|<2> Update Main Image File |
|<3> Update Backup Image File |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
15. Enter 0 in the Serial submenu to return to the EXTEND-BOOTWARE menu.
16. Enter 1 in the EXTEND-BOOTWARE menu to run the new software.
17. Change the baud rate of the HyperTerminal back to 9600 bps, and reconnect to the switch.
Upgrading BootWare from the BootWare menu
Upgrade the BootWare program from the BootWare menu by using one of the following methods:
Using TFTP to upgrade through the management Ethernet port
Using FTP to upgrade through the management Ethernet port
Using Xmodem to upgrade through the console port
For more information about BootWare, see "Using BootWare menus."
NOTE:
The switch does not come with FTP or TFTP software. Prepare the software yourself.
Upgrading through an Ethernet port is faster than through the console port.
Using TFTP to upgrade through the management Ethernet port
1. Connect the management Ethernet port of the switch to the PC that stores the source .bin BootWare
image, and connect the console port of the switch to the configuration terminal.
The configuration terminal can be co-located with the TFTP server.
2. Run the TFTP server program on the PC connected to the management Ethernet port, and specify
the file storage directory.
3. Run the terminal emulation program on the PC connected to the console port.
4. Start the switch and access the EXTEND-BOOTWARE menu (see "Using BootWare menus").
5. Enter 7 in the EXTEND-BOOTWARE menu to access the BootWare Operation menu.
=========================<BootWare Operation Menu>==========================
|Note:the operating device is flash |
|<1> Backup Full BootWare |
|<2> Restore Full BootWare |