HP 10500 Switch Series - HP 10500-CMW710-R2105-B Release Notes

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve 8116fl Redundant Switch Fabric Module

Option

Task

<2> Update Extend BootWare

Update the extended BootWare segment.

If the corrupted extended segment has corrupted, choose this

option to repair it.

<3> Update Full BootWare

Update the entire BootWare, including the basic segment

and the extended segment.

<4> Boot Extend BootWare

Run the primary extended BootWare segment.

<5> Boot Backup Extend BootWare

Run the backup extended BootWare segment.

<0> Reboot

Reboot the device.

Ctrl+U: Access BASIC ASSISTANT MENU

Press Ctrl + U to access the BASIC ASSISTANT menu.

Modifying serial port parameters

When using the console port to access the system, make sure the port parameters are consistent with the

serial port settings on the configuration terminal, including the baud rate, data bits, parity check, stop

bits, flow control, and emulation. If the settings are inconsistent, communication will fail.

With BootWare, you can change the baud rate. HP recommends that you change the default baud rate

(9600 bps) to a higher baud rate for faster file transfer before downloading a Comware image file with

XMODEM through the console port.

To change the baud rate of the console port:

1. Enter 1 in the BASIC-BOOTWARE menu.

Enter your choice(0-5): 1

===============================<BAUDRATE SET>===============================

|Note:'*'indicates the current baudrate |

| Change The HyperTerminal's Baudrate Accordingly |

|---------------------------<Baudrate Available>---------------------------|

|<1> 9600(Default)* |

|<2> 19200 |

|<3> 38400 |

|<4> 57600 |

|<5> 115200 |

|<0> Exit |

============================================================================

Enter your choice(0-5):

2. Enter the number that represents the baud rate you want to choose. For example, enter 5 to set the

baud rate to 115200 bps.

NOTE:

The baud rate change is a one-time operation. The baud rate will restore to the default (9600 bps) at

reboot. To set up a console session with the device after a reboot, you must change the baud rate setting

on the configuration terminal back to 9600 bps.

Updating the extended BootWare segment

If the extended BootWare segment has been corrupted, enter 2 in the BASIC-BOOTWARE menu to

update it.