HP 11900 Switch Series - HP 11900-CMW710-R2105 Release Notes

29
Enter your choice(0-4):
11. Enter 0 to return to the BootWare Operation menu.
12. Enter 0 in the BootWare Operation menu to return to the EXTEND-BOOTWARE menu.
13. Enter 0 in the EXTEND-BOOTWARE menu to reboot the switch.
Using Xmodem to upgrade through the console port
1. Connect the console port of the switch to the PC that stores the source .bin BootWare image.
2. Run the terminal emulation program on the PC.
3. Start the switch and access the EXTEND-BOOTWARE menu (see "Using BootWare menus").
4. Enter 7 in the EXTEND-BOOTWARE menu to access the BootWare Operation menu.
=========================<BootWare Operation Menu>==========================
|Note:the operating device is flash |
|<1> Backup Full BootWare |
|<2> Restore Full BootWare |
|<3> Update BootWare By Serial |
|<4> Update BootWare By Ethernet |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
5. Enter 3 in the BootWare Operation menu to access the Serial submenu.
====================<BOOTWARE OPERATION SERIAL SUB -MENU>====================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
6. Enter 4 in the Serial submenu to change the baud rate of the console port.
===============================<BAUDRATE SET>===============================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|---------------------------<Baudrate Available>---------------------------|
|<1> 9600(Default)* |
|<2> 19200 |
|<3> 38400 |
|<4> 57600 |
|<5> 115200 |
|<0> Exit |
============================================================================
Enter your choice(0-5):2
7. Enter an appropriate baud rate option. For example, enter 2 to select 19200 bps.
Baudrate has been changed to 19200 bps.
Please change the terminal's baudrate to 19200 bps, press ENTER when ready.