HP 12500 Switch Series - 12500-CMW710-R7129 Release Notes

Add images to target slot.

The specified file list will be used as the main startup software images at the

next reboot on slot 0.

3. Perform the display boot-loader command in user view to verify that the file has been

loaded.

<Sysname> display boot-loader

Software images on slot 0:

Current software images:

cfa0:/main-boot.bin

cfa0:/main-system.bin

Main startup software images:

cfa0:/update-boot.bin

cfa0:/update-system.bin

Backup startup software images:

None

4. Perform the reboot command in user view to reboot the switch.

<Sysname> reboot

Start to check configuration with next startup configuration file, please wait..

.......DONE!

This command will reboot the device. Continue? [Y/N]:y

Now rebooting, please wait...

%Sep 16 07:53:35:583 2012 HP DEV/5/SYSTEM_REBOOT: -MDC=1; System is rebooting no

DDR2 SDRAM test successful.

5. After the reboot is complete, perform the display version command to verify that the system

software image is correct.

Using FTP to upgrade software

This section describes how to upgrade system software by using FTP.

Backing up the running Comware software images and configuration

1. Use the save command in any view to save the running configuration.

<Sysname> save

The current configuration will be written to the device. Are you sure? [Y/N]:y

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

flash:/startup.cfg exists, overwrite? [Y/N]:y

Validating file. Please wait...

Saved the current configuration to mainboard device successfully.

Chassis 1 Slot 0:

Save next configuration file successfully.