HP FlexFabric 11900 Switch Series - HP 11900-CMW710-R2105P05 Release Notes

List of resolved problems
Resolved problems in R2105P05
201311180070
• Symptom: Addressed SSRT101324. A security bulletin for SSRT101324 should be published
in January 2014. Please see the security bulletin for additional details.
• Condition: Addressed SSRT101324. A security bulletin for SSRT101324 should be published
in January 2014. Please see the security bulletin for additional details.
201311190146
• Symptom: The speed 1000 command cannot be configured.
• Condition: This symptom can be seen on 10G port with fiber transceiver.
201311210247
• Symptom: The arp source-mac threshold command cannot work.
• Condition: This symptom can be seen when the arp source-mac threshold command is used.
201306140334
• Symptom: If an SF card is inserted into slot 0 of the IRF master switch, the IRF subordinate switch
might print temperature alarms, and the SF card might fail to start up.
• Condition: This symptom might occur if an SF card is inserted into slot 0 of the IRF master switch
201307290038
• Symptom: The port rate information in the output from the display interface command is incorrect.
• Condition: This symptom can be seen in the output from the display interface command.
201308010257
• Symptom: max-ecmp-num default configuration will be saved on the standby MPU.
• Condition: This symptom can be seen when both active and standby MPUs exist.
LSV7D006680
• Symptom: The internal port monitoring function is not enabled after the switch is rebooted using
default settings.
• Condition: This symptom can be seen after the switch is rebooted using default settings.
LSV7D008401
• Symptom: An AVGAO 10G SPF+ transceiver module might fail to come up.
• Condition: This symptom might occur if the AVGAO 10G SPF+ transceiver module is installed on
a TGS48SF card.
Resolved problems in R2105
None
6