HP FlexFabric 11900 Switch Series - HP 11900-CMW710-R2105P05 Release Notes

Perform the following tasks as needed:

• Upgrade BootWare

• Upgrade Comware software

• Install a patch package

1. Upgrade BootWare

The following example uses new.bin to upgrade the BootWare.

NOTE:

The

BootWare image stored on the active MPU can be used to upgrade the active MPU, LPUs, and

switching fabric modules while that stored on a standby MPU is used to upgrade the standby MPU only.

# Upgrade the BootWare on the global active MPU.

<Sysname> bootrom update file flash:/new.bin chassis 1 slot 4

This command will update bootrom file on the specified board(s),

Continue? [Y/N]:y

Now updating the Boot ROM, please wait........... ...........Done.

# Upgrade the BootWare of the standby MPU in slot 5 of member device 1. (Upgrade other

standby MPUs in the same way.)

<Sysname>bootrom update file chassis1#slot5#flash:/new.bin chassis 1 slot 5

This command will update bootrom file on the specified board(s), Continue? [Y/N]:y

Now updating the Boot ROM, please wait........... ...........Done.

# Upgrade the BootWare of the LPU in slot 3 of member device 2. (Upgrade other LPUs in the same

way.)

<Sysname>bootrom update file flash:/new.bin chassis 2 slot 3

This command will update bootrom file on the specified board(s), Continue? [Y/N]:y

Now updating the Boot ROM, please wait........... ...........Done.

# Upgrade the BootWare of the switching fabric module in slot 6 of member device 2. (Upgrade

other switching fabric modules in the same way.)

<Sysname>bootrom update file flash:/new.bin chassis 2 slot 6

This command will update bootrom file on the specified board(s), Continue? [Y/N]:y

Now updating the Boot ROM, please wait........... ...........Done.

# Reboot the IRF fabric to complete the upgrade.

<Sysname> reboot

Start to check configuration with next startup configuration file, please wait.

........DONE!

This command will reboot the device. Continue? [Y/N]:y

Now rebooting, please wait...

2. Upgrade Comware software

The following example uses newest.ipe to upgrade Comware software.

# Decompress the file newest.ipe on the global active MPU (in slot 4).

<HP>install add flash:/newest.ipe flash:

Verifying image file...Done.

This operation will take several minutes, please wait...........................

....................................................Done.

In this example, the decompressed images files include a boot image

11908-CMW710-BOOT-E2102.bin and a system image 11908-CMW710-SYSTEM-E2102.bin.