HP FlexFabric 11900 Switch Series - HP 11900-CMW710-R2105P05 Release Notes

The Extend BootWare is self-decompressing................
Done!
Accessing the BASIC ASSISTANT menu
To access the BASIC ASSISTANT BOOTWARE menu, press Ctrl+U while you are in the
BASIC-BOOTWARE menu.
===========================<BASIC ASSISTANT MENU>===========================
|<1> RAM Test |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-1):
Table 14 BASIC ASSISTANT menu
Option Task
<1> RAM Test Perform a RAM test.
<0> Exit to Main Menu Return to the BASIC-BOOTWARE menu.
To perform a RAM test, press Ctrl+T within 4 seconds after the prompt message "Press Ctrl+T to start
memory test" appears.
To perform a RAM pressure test, press Ctrl+V within 4 seconds after the prompt message "Press Ctrl+V
to start heavy memory test" appears.
If a RAM test is required, do that under the guidance of an HP technical support engineer.
Using the EXTEND-BOOTWARE menu
To access the EXTEND-BOOTWARE menu:
1. Reboot the device or run the primary or backup extended BootWare segment from the
BASIC-BOOTWARE menu.
2. Press Ctrl+B within 5 seconds after the "Press Ctrl+B to access EXTENDED-BOOTWARE MENU..."
prompt message appears. If you fail to do this, the system starts decompressing the Comware
software file.
Password recovery capability is enabled.
Note: The current operating device is flash
Enter < Storage Device Operation > to select device.
3. Press Enter at the prompt for password.
The EXTEND-BOOTWARE menu appears.
===========================<EXTEND-BOOTWARE MENU>===========================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Restore to Factory Default Configuration |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Skip Authentication for Console Login |
38