Release Notes for H3C S7500E, Comware 5.20 Release 6305 Patch 02. Models: 0235A25N, 0235A27Q, 0235A27R, 0235A27S, 0235A29A, 0235A33R

Hangzhou H3C Technologies Co., Ltd.

H3C S7500E-CMW520-R6305P02 Release

Notes

2009-3-5 Page 28 of 29

3. Set XMODEM protocol parameter

0. Return

Enter your choice(0-3):1

Step 5: Enter 1 in the download program menu. Select to use TFTP for the software

upgrading. Press <Enter> and the screen will display the following information:

Please modify your TFTP protocol parameter:

Load File name

Switch IP address

Server IP address

Step 6: Complete the relevant information based on the actual requirements and

press <Enter>. The screen will display the following information:

Are you sure to download file to flash? Yes or No(Y/N)

Step 7: Enter Y and the system starts downloading the file. Enter N and the system

will return to Boot menu. Take entering Y as an example. Enter Y and press <Enter>,

the system begins downloading programs. After the downloading is completed, the

system starts write-flash operation. Upon completion of this operation, the screen

displays the following information to indicate that the downloading is completed:

Loading ........................................................done!

Writing to flash................................................done!

2. Software Upgrading via FTP

1) Introduction to FTP

Through the Ethernet port, the S7500 can serve as an FTP server or client. It

provides another means to download the system program and configure the files. In

the following description we assume that the S7500 serves as an FTP client.

2) FTP upgrading procedure

Step 1: Select an Ethernet interface for downloading on the S7500. Connect the

switch to the PC (where the upgrading file is located and whose IP address should be

known) via the interface. At the same time, you should connect the switch to a PC via

the Console port (the PC should be the same as the PC where the upgrading file is

located).

Step 2: Run the FTP server program on the PC connected to the Ethernet interface

for upgrading, and specify the file path of the upgrading program.

Step 3: Run the terminal emulation program on the PC connected to the Console port,