Release notes - H3C S7500-CMW310-R3234P03

Hangzhou H3C Technologies Co., Ltd.
H3C S7500-CMW310-R3234P03 Release
Notes
2011-8-17
Page 23 of 25
Loading ........................................................done
Writing to flash................................................done
8.4 Software Upgrading via Ethernet Interface (FTP/TFTP)
1. Software Upgrading via TFTP
1) Introduction to TFTP
TFTP (trivial file transfer protocol) is a type of simple file transfer protocol in the
TCP/IP protocol suite that applies between clients and servers. TFTP is normally
realized on the UDP basis to provide unreliable data transfer service.
2) TFTP upgrading procedure
Step 1: Select an Ethernet interface for downloading on the S7500. Connect the
switch to the PC (where the upgrading file is located) via the interface. At the same
time, you should connect the switch to a PC via the console port (The PC should be
the same as the PC where the upgrading file is located).
Step 2: Run the TFTP server program on the PC connected with the Ethernet
interface for upgrading, and specify the file path of the upgrading program.
Caution:
H3C series switches are not shipped with TFTP Server program.
Step 3: Run the terminal emulation program on the PC connected to the Console port,
and boot the switch to access the Boot menu.
Step 4: Enter 1 in the Boot menu. Press <Enter> and the system will access the
download program menu.
Please set application file download protocol parameter:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return
Enter your choice(0-3):1
Step 5: Enter 1 in the download program menu. Select to use TFTP for the software
upgrading. Press <Enter> and the screen will display the following information:
Please modify your TFTP protocol parameter:
Load File name
Switch IP address