Release Notes - H3C S7500E-CMW520-R6616P05

H3C S7500E-CMW520-R6616P05 Release Notes
Hangzhou H3C Technologies Co., Ltd.
29
<Sysname> copy newest.app chassis2#slot0#flash:/
Copy flash:/newest.app to chassis2#slot0#flash:/newest.app?[Y/N]:y
%Copy file flash:/newest.app to chassis2#slot0#flash:/newest.app...Done.
 On the standby main board in slot 1 of member device 2
<Sysname> copy newest.app chassis2#slot1#flash:/
Copy flash:/newest.app to chassis2#slot1#flash:/newest.app?[Y/N]:y
%Copy file flash:/newest.app to chassis2#slot1#flash:/newest.app...Done.
NOTE:
 You can configure the switch as the FTP server, FTP client, or TFTP client. The transfer processes
slightly vary. For more information about FTP and TFTP, see Fundamentals in the H3C S7500E Series
Ethernet Switches Configuration Guide.
 You can use the transfer procedure described in this section to transfer boot files, and patches files
for upgrade from the CLI.
Upgrade software from the CLI
NOTE:
Make sure that the upgrade files exist in the root directory of the storage medium of the active main
board and that of each standby main board of the IRF virtual device.
Perform the following tasks as needed:
 Upgrade boot files
 Install patches
1. Upgrade boot files
# Specify the file newest.app as the main boot file to be used at the next startup of the active main
board of the virtual IRF device.
<Sysname> boot-loader file newest.app chassis 1 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 0!
# Specify the file newest.app as the main boot file to be used at the next startup of the standby main
boards of the virtual IRF device.
 On the standby main board in slot 1 of member device 1
<Sysname> boot-loader file chassis1#slot1#flash:/newest.app chassis 1 slot 1 main
This command will set the boot fi le of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 1!
 On the standby main board in slot 0 of member device 2
<Sysname> boot-loader file chassis2#slot0#flash:/newest.app chassis 2 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2
slot 0!
 On the standby main board in slot 1 of member device 2
<Sysname> boot-loader file chassis2#slot1#flash:/newest.app chassis 2 slot 1 main