Release notes - H3C S9500-CMW310-R1652P03

Hangzhou H3C Technologies Co., Ltd.
H3C S9500-CMW310-R1652P03
Release Notes
2010-9-27 Page 55 of 56
ACL 3010 rule 1 sets the source and destination IP addresses; ACL 4000 rule 1 sets
local VLAN and destination MAC address (virtual interface MAC address of the local
VLAN).
2) It is necessary to customize a traffic flow template and apply it to the port where
QACL redirection is to be configured, because the required DMAC field for QACL
redirection configuration does not exist in the default traffic flow template.
8.3.3 Upgrading for XP4B/CA
1) Version 12XX supports port group concept, and the QACL configuration for
XP4B/CA boards are made based on port group.
[H3C-port-group302] flow-template user-defined
[H3C-port-group302] packet-filter inbound ip-group 3010 rule 0
[H3C-port-group302] display this
#
port-group 302
flow-template user-defined
packet-filter inbound ip-group 3010 rule 0 system-index 1
#
2) Before the version is upgraded to version 16XX, it is required to remove port group
configuration. After successful upgrade, it is necessary to configure the same QACL
on the corresponding primary port.
[H3C-GigabitEthernet1/1/1] flow-template user-defined
[H3C-GigabitEthernet1/1/1] packet-filter inbound ip-group 3010 rule 0
An XP4B/CA board has four ports, whose port numbers are 0 to 3. The customized
traffic flow template and QACL can be configured only on ports 0 and 2. When the
configuration is made on port 0, the configuration takes effect on both ports 0 and 1;
When the configuration is made on port 2, the configuration takes effect on both ports
2 and 3.
Caution:
1. Some commands change with the upgrade from version 12XX to 16XX. You need
to change the configuration file manually. For detailed information about command
changes, refer to Command Changes for Version Upgrade to 16XX.