Switch 7700 V2.00 Release Notes

RELEASE ISSUES FOR THE SWITCH 7700 V2.0
2.10. Documentation
Symptom Solution
The radius 3com-type parameter for the
radius server-type command no longer exists.
Do not use this parameter.
In the Switch 7700 Installation Guide, in Table
21, on the Link aggregation row, the last line
says, "…up to 24 ports."
This line should say, “…up to 16 ports.”
In the Switch 7700 Command Reference
Guide, the mirroring-port command no longer
exists. Also, the monitor port command no
longer exists.
Use the mirroring group command instead.
In the Switch 7700 Command Reference
Guide, the display acl runtime command no
longer exists.
Use the display acl running-packet-filter
command instead.
In the Switch 7700 Command Reference
Guide, the qos-info command no longer
exists.
Use the display qos-interface all command
instead.
The Switch 7700 Command Reference Guide
is missing an NBX command for high
prioritization of packets.
Use the following commands to allow high
priority for NBX packets:
[SW7700]
[SW7700]nbx-priority local-
precedence 7
[SW7700]priority-trust local-
precedence
[SW7700]rdram disable
In the Switch 7700 Command Reference
Guide, the DHCP-relay command no longer
exists.
Do not use DHCP-relay commands. Instead,
use the following commands:
Interface vlan-interface vlannumber
dhcp-server dhcpserver groupnumber
In section 6.4.43, page 131 of the Switch 7700
Command Reference Guide, it incorrectly
states that the system uses the smallest IP
address of all the router interfaces as the router
ID.
Use the display ospf brief command to read
the selected interface. You can also use the
router id command to select the router ID
interface manually.
7