Installation Guide for fl Modules 2007-02

ProCurve Switch fl Modules

Installing Modules

1. Pull out upper ejector

lever and hold it in

unlocked position.

Note

2. Install interface modules in any

of the numbered slots on the left

and right side of the chassis.

3. Push ejectors in to

secure and tighten

captive screws.

Interface

Module

Metal Plate

Module Guides

An interface module must be fully seated and the ejectors must be fully

locked (vertical) before the captive screws will align properly. Also, by

fully seating the module, you ensure proper contact of the module with

the backplane, which is necessary for optimal performance.

Repeat steps 1 to 6 to install any additional interface modules.

If you have installed an X2 10GbE Interface Module, you can now install

a transceiver in the module (see page 25).

If you have installed a 10-Port Mini-GBIC Interface Module, you can now

install mini-GBICs in the module (see page 27).