3Com Switch 8800 Advanced Software V5 Configuration Guide

Device Management Configuration Example 1009
Device Management
Configuration
Example
Remote Upgrade
Configuration Example
Network requirements
■ Switch A serves as the FTP Client. The aaa.app program and the boot.app
program are both saved under the aaa directory of the FTP Server.
■ The IP address of Vlan-interface 2 on Switch A is 1.1.1.1/24, the IP address of
the FTP Server is 2.2.2.2/24, and the IP address of User is 3.3.3.3/24.
■ A route exists between the FTP server, Switch A and User.
■ User can log in to Switch A via Telnet to perform operations on Switch A (that
is, download the application program from FTP Server and remotely upgrade
Switch A through command lines).
Network diagram
Figure 302 Network diagram for remote upgrade
Configuration procedure
1 Configure the IP address of each device and a route between FTP server and
Switch A, Switch A and User.
Configure the IP address of each device as shown in Figure 302
Display the usage of the
memory of a device
display memory [ slave |
slot slot-number ]
Available in any view
Display the power state of a
device
display power [ power-id ] Available in any view
Display the reboot time of a
device
display schedule reboot Available in any view
Display the load mode of the
current active and standby
cards
display xbar Available in any view
To do... Use the command... Remarks
FTP Client
FTP Server
User
Telnet
Switch A
Vlan-interface2
1.1.1.1/24
2.2.2.2/24
Internet
3.3.3.3/24