3Com Switch 8800 Advanced Software V5 Configuration Guide

1054 CHAPTER 83: SNMP CONFIGURATION
Displaying and
Maintaining SNMP
SNMP Configuration
Examples
Network requirements
■ The NMS connects to the agent, a switch, through an Ethernet.
■ The IP address of the NMS is 129.102.149.23/16.
■ The IP address of VLAN interface on the switch is 129.102.0.1/16.
■ On the switch, configure the following: community name, access right,
administrator ID, contact, location, enabling sending of Trap messages.
Network diagram
Figure 310 Network diagram for SNMP
Configuration procedure
1 Configuring SNMP Agent
# Configure the community name, the SNMP agent group, and SNMP agent user.
<Sysname> system-view
[Sysname] snmp-agent sys-info version all
To do... Use the command... Remarks
Display SNMP-agent system
information, including the
contact, location, and version
of the SNMP
display snmp-agent
sys-info [ contact | location |
version ]*
Available in any view
Display SNMP agent statistics display snmp-agent
statistics
Display the SNMP agent
switch fabric ID
display snmp-agent
local-switch fabricid
Display SNMP agent group
information
display snmp-agent group [
group-name ]
Display SNMP v3 agent user
information
display snmp-agent
usm-user [ switch fabricid
switch fabricid | username
user-name | group
group-name ] *
Display SNMP v1 or v2c agent
community information
display snmp-agent
community [ read | write ]
Display MIB view information
for an SNMP agent
display snmp-agent
mib-view [ exclude | include
| viewname view-name ]
IP network
Terminal
Agent
NMS
Console
Vlan-int2
129.102 .0.1/16
129.102.149 .23/16