3Com Switch 8800 Advanced Software V5 Configuration Guide

NTP Configuration Examples 1077
Peer dispersion: 0.00 ms
Reference time: 00:00:00.000 UTC Jan 1 1900 (00000000.00000000)
# Specify Device A as the NTP server.
<DeviceB> system-view
[DeviceB] ntp-service unicast-server 1.0.1.11
# (After the above configurations, Device B is synchronized to Device A.) View the
NTP status of Device B after clock synchronization.
[DeviceB] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 1.0.1.11
Nominal frequency: 64.0000 Hz
Actual frequency: 64.0000 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 31.00 ms
Root dispersion: 1.05 ms
Peer dispersion: 7.81 ms
Reference time: 14:53:27.371 UTC Sep 19 2005 (C6D94F67.5EF9DB22)
As shown above, Device B has been synchronized to Device A, and the clock
stratum level of Device B is 3, while that of Device A is 2.
# View the NTP session information of Device B, which shows that an association
has been set up between Device B and Device A.
[DeviceB] display ntp-service sessions
source reference stra reach poll now offset delay disper
**************************************************************************
[12345] 1.0.1.11 127.127.1.0 2 63 64 3 -75.5 31.0 16.5
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations : 1
Configuring the NTP
Symmetric Mode
Network requirements
The local clock of Device A is to be configured as a reference source, with the
stratum level of 2. Device A is to be used as the NTP server of Device B, with
Device B as the client, and Device A then as the server automatically. At the same
time, Device B acts as the peer of Device C, with Device C as the symmetric-active
peer and Device B as the symmetric-passive peer.