3Com Switch 8800 Advanced Software V5 Configuration Guide

Configuring NQA Tests 1091
■ “Configuring the DHCP Test” on page 1093
■ “Configuring the FTP Test” on page 1094
■ “Configuring the HTTP Test” on page 1096
■ “Configuring the Jitter Test” on page 1098
■ “Configuring the SNMP Query Test” on page 1101
■ “Configuring the TCP Test” on page 1103
■ “Configuring the UDP Test” on page 1105
■ “Configuring the DLSw Test” on page 1107
Configuring the ICMP
Test
The ICMP test is mainly used to test whether an NQA client can send packets to a
specified destination and test the roundtrip time of packets.
Configuration procedure
Follow these steps to configure the ICMP test:
To do... Use the command... Remarks
Enter system view system-view -
Enable the NQA client nqa-agent enable Required
Create an NQA test group
and enter its view
nqa admin-name
operation-tag
-
Set the test type to ICMP test-type icmp Optional
ICMP by default.
Configure a destination
address for a test
destination-ip ip-address Required
Configure the size of test
packets sent
datasize size Optional
56 bytes by default.
Configure a string of fill
characters of a test packet
datafill text Optional
The string of fill characters of
an ICMP packet is the string
corresponding with the ASCII
code 00 to 09 by default.
Specify a VPN instance vpninstance name Optional
No VPN instance is specified
by default. When there are
multiple VPNs, you need to
use this command to specify a
VPN instance for test.
Specify the IP address of an
interface as the source IP
address of an ICMP test
request packet
source-interface
interface-type
interface-number
Optional
The interface specified by this
command can only be a layer
3 Ethernet interface or VLAN
interface. In addition, the
interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
Refer to “Configuring
Optional Parameters for NQA
Tests” on page 1109.
Optional
Enable the NQA test test-enable Required