3Com Switch 8800 Advanced Software V5 Configuration Guide

1094 CHAPTER 86: NQA CONFIGURATION
Figure 323 Network diagram for the DHCP test
3 Configuration procedure
n
For the configuration of DHCP Server, refer to “DHCP Server Configuration” on
page 721.
Perform the following configurations on Switch A:
# Enable the NQA client, create a DHCP test group, and configure related test
parameters.
<SwitchA> system-view
[SwitchA] nqa-agent enable
[SwitchA] nqa admin dhcp
[SwitchA-nqa-admin-dhcp] test-type dhcp
[SwitchA-nqa-admin-dhcp] source-interface Vlan-interface 2
# Enable the DHCP test.
[SwitchA-nqa-admin-dhcp] test-enable
# View the test results with the display nqa results command.
[SwitchA-nqa-admin-dhcp] display nqa results admin dhcp
NQA entry(admin admin, tag dhcp) test result:
Send operation times: 1 Receive response times: 1
Min/Max/Average Round Trip Time: 527/527/527
Square-Sum of Round Trip Time: 277729
Last succeeded test time: 2006-06-07 13:15:07.3
Extend result:
Packet lost in test: 0%
Failures due to Timeout: 0
Failures due to System Busy: 0
Failures due to Disconnect: 0
Failures due to No Connection: 0
Failures due to Sequence Error: 0
Failures due to Internal Error: 0
Failures due to Other Errors: 0
Configuring the FTP Test The FTP test is mainly used to test the connection with a specified FTP server and
the time necessary for the FTP client to transfer a file to the FTP server.
Configuration prerequisites
Before the FTP test, you need to perform some configurations on the FTP server.
For example, you need to configure the username and password used to log onto
the FTP server. For the FTP server configurations, refer to
“FTP Configuration” on
page 1037.
NQA client
Switch BSwitch A
Vlan-int2
10.1.1.1/16
Vlan-int2
10 .1 .1.2/ 16
DHCP server