3Com Switch 8800 Advanced Software V5 Configuration Guide

Configuring NQA Tests 1097
Configuration procedure
Follow these steps to configure the HTTP test:
Configuration example
1 Network requirements
Use the HTTP function to test the connection with a specified HTTP server and the
time required to obtain data from the HTTP server.
2 Network diagram
Figure 325 Network diagram for the HTTP test
3 Configuration procedure
Perform the following configurations on Switch A:
# Enable the NQA client, create an HTTP test group, and configure related test
parameters.
<Switch> system-view
[Switch] nqa-agent enable
[Switch] nqa admin http
[Switch-nqa-admin-http] test-type http
[Switch-nqa-admin-http] destination-ip 10.2.2.2
To do... Use the command... Remarks
Enter system view system-view -
Enable the NQA client nqa-agent enable Required
Create an NQA test group
and enter its view
nqa admin-name
operation-tag
-
Set the test type to HTTP test-type http Required
Configure a destination
address for a test
destination-ip ip-address Required
Here it is the IP address of the
HTTP server.
Configure the HTTP operation
type
http-operation { get | post } Optional
get by default, meaning to
get data from the HTTP
server.
Configure an HTTP operation
string
http-string string version Required
Configure common optional
parameters
Refer to “Configuring
Optional Parameters for NQA
Tests” on page 1109
Optional
Enable the NQA test test-enable Required
View the test results display nqa results [
admin-name operation-tag ]
Required
You can execute the
command in any view.
IP network
NQA client
Switch BSwitch A
10.1.1.1/16 10.2.2.2/16
HTTP server