3Com Switch 8800 Advanced Software V5 Configuration Guide

Configuring NQA Tests 1101
Failures due to Sequence Error: 0
Failures due to Internal Error: 0
Failures due to Other Errors: 0
Jitter result:
RTT Number: 10
SD Maximal delay: 4 DS Maximal delay: 4
Min Positive SD: 1 Min Positive DS: 0
Max Positive SD: 1 Max Positive DS: 0
Positive SD Number: 1 Positive DS Number: 0
Positive SD Sum: 1 Positive DS Sum: 0
Positive SD average: 0 Positive DS average: 0
Positive SD Square Sum: 1 Positive DS Square Sum: 0
Min Negative SD: 1 Min Negative DS: 1
Max Negative SD: 6 Max Negative DS: 1
Negative SD Number: 2 Negative DS Number: 1
Negative SD Sum: 7 Negative DS Sum: 1
Negative SD average: 4 Negative DS average: 1
Negative SD Square Sum: 37 Negative DS Square Sum: 1
SD lost packets number: 0 DS lost packet number: 0
Unknown result lost packet number: 0
Configuring the SNMP
Query Test
The SNMP query test is used to test the time the NQA client takes to send an
SNMP query packet to the SNMP agent and then receive a response packet.
Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP
agent.
Configuration procedure
Follow these steps to configure the SNMP query test:
Configuration example
1 Network requirements
Use the NQA SNMP query function to test the time it takes Switch 1 to send an
SNMP query packet to the SNMP agent and receive a response packet.
2 Network diagram
To do... Use the command... Remarks
Enter system view system-view -
Enable the NQA client nqa-agent enable Required
Create an NQA test group
and enter its view
nqa admin-name
operation-tag
-
Set the test type to SNMP
query
test-type snmpquery Required
Configure a destination
address for a test
destination-ip ip-address Required
Configure common optional
parameters
Refer to “Configuring
Optional Parameters for NQA
Tests” on page 1109.
Optional
Enable the NQA test test-enable Required
View the test results display nqa results [
admin-name operation-tag ]
Required
You can execute the
command in any view.