3Com Switch 8800 Advanced Software V5 Configuration Guide

1104 CHAPTER 86: NQA CONFIGURATION
Configuration example
1 Network requirements
Use the NQA TCP-Private function to test the time for setting up a TCP connection
between the local port (Switch 1) and the specified destination port (Switch 2).
The port number used is 9000.
2 Network diagram
Figure 328 Network diagram for the TCP-Private test
3 Configuration procedure
■ Configuration on Switch 2
# Enable the NQA server and configure the listening IP address and port number.
<Switch> system-view
[Switch] nqa-server enable
[Switch] nqa-server tcpconnect 10.2.2.2 9000
■ Configuration on Switch 1
# Enable the NQA client, create a TCP test group, and configure related test
parameters.
<Switch> system-view
[Switch] nqa-agent enable
[Switch] nqa admin tcpprivate
[Switch-nqa-admin-tcpprivate] test-type tcpprivate
[Switch-nqa-admin-tcpprivate] destination-ip 10.2.2.2
[Switch-nqa-admin-tcpprivate] destination-port 9000
Configure a destination
address for a test
destination-ip ip-address Required
The destination address must
be the listening IP address on
the NQA server.
Configure a destination port destination-port
port-number
If the test type is TCP-Public,
no port needs to be
configured. If the test type is
TCP-Private, a port must be
configured and it must be the
listening port configured on
the NQA server.
Configure common optional
parameters
“Configuring Optional
Parameters for NQA Tests” on
page 1109
Optional
Enable the NQA test test-enable Required
View the test results display nqa results [
admin-name operation-tag ]
Required
You can execute the
command in any view.
To do... Use the command... Remarks
Switch 2Switch 1
IP network
NQA client
10.1.1.1/8 10.2.2.2/8
NQA server