3Com Switch 8800 Advanced Software V5 Configuration Guide

Configuring NQA Tests 1107
2 Network diagram
Figure 329 Network diagram for the UDP-Private test
3 Configuration procedure
■ Configuration on Switch 2
# Enable the NQA server and configure the listening IP address and port number.
<Switch> system-view
[Switch] nqa-server enable
[Switch] nqa-server udpecho 10.2.2.2 8000
■ Configuration on Switch 1
# Enable the NQA client, create a UDP-Private test group, and configure related
test parameters.
<Switch> system-view
[Switch] nqa-agent enable
[Switch] nqa admin udpprivate
[Switch-nqa-admin-udpprivate] test-type udpprivate
[Switch-nqa-admin-udpprivate] destination-ip 10.2.2.2
[Switch-nqa-admin-udpprivate] destination-port 8000
# Enable the TCP test.
[Switch-nqa-admin-udpprivate] test-enable
# View the test results with the display nqa results command.
[Switch-nqa-admin-udpprivate] display nqa results admin udpprivate
NQA entry(admin admin, tag udpprivate) test result:
Destination ip address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average Round Trip Time: 11/11/11
Square-Sum of Round Trip Time: 121
Last succeeded test time: 2009-08-15 15:26:01.8
Extend result:
Packet lost in test: 0%
Failures due to Timeout: 0
Failures due to System Busy: 0
Failures due to Disconnect: 0
Failures due to No Connection: 0
Failures due to Sequence Error: 0
Failures due to Internal Error: 0
Failures due to Other Errors: 0
Configuring the DLSw
Test
Data link switching (DLSw) was jointly developed by Advanced Peer-to-Peer
Networking (APPN) Implementers Workshop (AIW) and the Data-Link Switching
Related Interest Group (DLSw RIG) for transmitting Systems Network Architecture
IP network
NQA client
Switch 2Switch 1
10.1.1.1/8 10.2.2.2/8
NQA server