3Com Switch 8800 Advanced Software V5 Configuration Guide

1108 CHAPTER 86: NQA CONFIGURATION
(SNA) traffic over a TCP/IP network. The DLSw test is used to test the response
time of the DLSw device.
Configuration prerequisites
Before the DLSw test, a TCP connection can be set up between the NQA client
and the specified device.
Configuration procedure
Follow these steps to configure the DLSw test:
Configuration example
1 Network requirements
Use the NQA DLSw function to test the response time of the DLSw device.
2 Network diagram
Figure 330 Network diagram for the DLSw test
3 Configuration procedure
n
# Enable the NQA client, create a DLSw test group, and configure related test
parameters.
<Switch> system-view
[Switch] nqa-agent enable
[Switch] nqa admin dlsw
[Switch-nqa-admin-dlsw] test-type dlsw
[Switch-nqa-admin-dlsw] destination-ip 10.2.2.2
# Enable the DLSw test.
[Switch-nqa-admin-dlsw] test-enable
To do... Use the command... Remarks
Enter system view system-view -
Enable the NQA client nqa-agent enable Required
Create an NQA test group
and enter its view
nqa admin-name
operation-tag
-
Set the test type to DLSw test-type dlsw Required
Configure a destination
address for a test
destination-ip ip-address Required
Configure common optional
parameters
Refer to “Configuring
Optional Parameters for NQA
Tests” on page 1109.
Optional
Enable the NQA test test-enable Required
View the test results display nqa results [
admin-name operation-tag ]
Required
You can execute the
command in any view.
NQA client
Switch1
IP network
Switch2
10.1.1.1/8 10.2.2.2/8
DLSw