3Com Switch 8800 Advanced Software V5 Configuration Guide

1126 CHAPTER 88: INFORMATION CENTER CONFIGURATION
Setting to Output
System Information to
the Trap Buffer
Setting to Output
System Information to
the Log Buffer
Configure the source
interface through which log
information can be output to
a log host
info-center loghost source
interface-type
interface-number
Optional
No source interface is
configured by default, and the
system selects an interface as
the source interface.
Configure the information
source for an information
channel
info-center source {
module-name | default }
channel { channel-number |
channel-name } [ debug {
level severity | state state } * |
log { level severity | state
state } * | trap { level severity
| state state } * ] *
Required
Configure the format of the
time stamp for log
information
info-center timestamp
loghost { date |
no-year-date | none }
Optional
date by default.
To do... Use the command... Remarks
To do... Use the command... Remarks
Enter system view system-view -
Enable information center info-center enable Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
Refer to Table 43 for default
channel names.
Configure the channel
through which system
information can be output to
the trap buffer and specify the
buffer size
info-center trapbuffer [
channel { channel-number |
channel-name } | size
buffersize ] *
Optional
System information is output
to the trap buffer by default
with channel 3 (known as
trapbuffer) as the default
channel and a default buffer
size of 256.
Configure the information
source for an information
channel
info-center source {
module-name | default }
channel { channel-number |
channel-name } [ debug {
level severity | state state } * |
log { level severity | state
state } * | trap { level severity
| state state } * ] *
Required
Configure the format of the
time stamp
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
The time stamp for log, trap
and debug information is
date by default.
To do... Use the command... Remarks
Enter system view system-view -
Enable information center info-center enable Optional
Enabled by default.