3Com Switch 8800 Advanced Software V5 Configuration Guide

Displaying and Maintaining Information Center 1129
n
■ If you do not input any information following the current command line
prompt, the system does not display any command line prompt after system
information output.
■ In the interaction mode, you are prompted for some information input. If the
input is interrupted by system output, no system prompt will be made, rather
only your input will be displayed in a new line.
Displaying and
Maintaining
Information Center
Information Center
Configuration
Examples
Outputting Log
Information to a Unix
Log Host
Network requirements
■ Send log information to a Unix log host with an IP address of 1.2.0.1/16;
■ Log information with severity higher than informational will be output to the
log host;
■ The source modules are ARP and IP.
To do... Use the command... Remarks
Enter system view system-view -
Enable synchronous
information output
info-center synchronous Required
Disabled by default
To do... Use the command... Remarks
Display channel information
for a specified channel
display channel [
channel-number |
channel-name ]
Available in any view
Display the configurations for
all information channels
except channel 6 to 8
display info-center Available in any view
Display the state of the log
buffer and the log
information recorded
display logbuffer [ level
severity | size buffersize | slot
slot number ] * [ | { begin |
exclude | include } text ]
Available in any view
Display a summary of the log
buffer
display logbuffer summary
[ level severity | slot slotnum ]
*
Available in any view
Display the content of the log
file buffer
display logfile buffer Available in any view
Display the configuration of
the log file
display logfile summary Available in any view
Display the state of the trap
buffer and the trap
information recorded
display trapbuffer [ size
buffersize ]
Available in any view
Reset the log buffer reset logbuffer Available in user view
Reset the trap buffer reset trapbuffer Available in user view