3Com Switch 8800 Advanced Software V5 Configuration Guide

GVRP Configuration Example 145
<SysnameB> system-view
[SysnameB] gvrp
# Configure port Ethernet1/1/2 as a trunk port, allowing all VLANs to pass.
[SysnameB] interface ethernet 1/1/2
[SysnameB-Ethernet1/1/2] port link-type trunk
[SysnameB-Ethernet1/1/2] port trunk permit vlan all
# Enable GVRP on Ethernet1/1/2, the trunk port.
[SysnameB-Ethernet1/1/2] gvrp
[SysnameB-Ethernet1/1/2] quit
# Create VLAN 3 (a static VLAN).
[SysnameB] vlan 3
[SysnameB-vlan3] return
3 Verify the configuration
# Display dynamic VLAN information on Switch A.
<SysnameA> display vlan dynamic
Total 1 dynamic VLAN exist(s).
The following dynamic VLANs exist:
3
# Display dynamic VLAN information on Switch B.
<SysnameB> display vlan dynamic
Total 1 dynamic VLAN exist(s).
The following dynamic VLANs exist:
2
GVRP Configuration
Example II
Network requirements
Configure GVRP for dynamic VLAN information registration and update between
the switches. Set the "fixed" GVRP registration mode on the trunk port of Switch
A and keep the default "normal" GVRP registration mode on the trunk port of
Switch B.
Network diagram
Figure 39 Figure 11-3 Network diagram for GVRP configuration
Configuration procedure
1 Configure Switch A
# Enable GVRP globally.
Ethernet1/1/1
Switch A
Switch B
Ethernet1/1/2