3Com Switch 8800 Advanced Software V5 Configuration Guide

146 CHAPTER 12: GVRP CONFIGURATION
<SysnameA> system-view
[SysnameA] gvrp
# Configure port Ethernet1/1/1 as a trunk port, allowing all VLANs to pass.
[SysnameA] interface ethernet 1/1/1
[SysnameA-Ethernet1/1/1] port link-type trunk
[SysnameA-Ethernet1/1/1] port trunk permit vlan all
# Enable GVRP on Ethernet1/1/1.
[SysnameA-Ethernet1/1/1] gvrp
# Set the GVRP registration type to fixed on the port.
[SysnameA-Ethernet1/1/1] gvrp registration fixed
[SysnameA-Ethernet1/1/1] quit
# Create VLAN 2 (a static VLAN).
[SysnameA] vlan 2
[SysnameA-vlan2] return
2 Configure Switch B
# Enable GVRP globally.
<SysnameB> system-view
[SysnameB] gvrp
# Configure port Ethernet1/1/2 as a trunk port, allowing all VLANs to pass.
[SysnameB] interface ethernet 1/1/2
[SysnameB-Ethernet1/1/2] port link-type trunk
[SysnameB-Ethernet1/1/2] port trunk permit vlan all
# Enable GVRP on Ethernet1/1/2.
[SysnameB-Ethernet1/1/2] gvrp
[SysnameB-Ethernet1/1/2] quit
# Create VLAN 3 (a static VLAN).
[SysnameB] vlan 3
[SysnameB-vlan3] return
3 Verify the configuration
# Display dynamic VLAN information on Switch A.
<SysnameA> display vlan dynamic
No dynamic VLAN exists!
# Display dynamic VLAN information on Switch B.
<SysnameB> display vlan dynamic
Total 1 dynamic VLAN exist(s).