3Com Switch 8800 Advanced Software V5 Configuration Guide

Displaying and Maintaining RIP Configuration 283
Displaying and
Maintaining RIP
Configuration
RIP Configuration
Examples
Configuring the RIP
Version
Network requirements
As shown in Figure 77, enable RIP-2 on all interfaces on Switch A and Switch B.
Network diagram
Figure 77 Network diagram for RIP version configuration
Configuration procedure
1 Configure an IP address for each interface (only the IP address configuration for
the VLAN interfaces is given in the following examples)
# Configure Switch A.
<SwitchA> system-view
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet1/1
[SwitchA-vlan100] quit
To do... Use the command... Remarks
Enter system view system-view --
Bind RIP to MIB rip mib-binding process-id Optional
By default, MIB is bound to
the RIP process with the
smallest process ID
To do... Use the command... Remarks
Display RIP current status and
configuration information
display rip [ process-id |
vpn-instance
vpn-instance-name ]
Available in any view
Display all active routes in RIP
database
display rip process-id
database
Display RIP interface
information
display rip process-id
interface [ interface-type
interface-number ]
Display routing information
about a specified RIP process
display rip process-id route [
statistics | ip-address { mask |
mask-length } | peer
ip-address ]
Clear the statistics of a RIP
process
reset rip process-id statistics Available in user view
Vlan-int102
172.16.1 .1/24
Vlan-int100
192.168.1 .2/24
Vlan-int102
10. 1.1 .2/ 24
Vlan-int100
192.168.1.3/24
Vlan-int101
10.2.1.1/24
Vlan-int101
172.17.1.1/24
Switch A Switch B
Eth1/1
Eth1/2