3Com Switch 8800 Advanced Software V5 Configuration Guide

RIPng Configuration Example 297
RIPng Configuration
Example
Network requirements
As shown in Figure 82, all switches run RIPng. The prefix length of all IP addresses
in the figure is 64, and neighboring switches use link-local IPv6 addresses for
interconnection.
Configure Switch B to filter the route (3::/64) learnt from Switch C, which means
the route will not be added to the routing table of Switch B, and Switch B will not
forward it to Switch A.
Network diagram
Figure 82 Network diagram for RIPng configuration
Configuration procedure
1 Configure the IPv6 address for each interface (omitted)
2 Configure basic RIPng functions
# Configure Switch A.
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface Vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
[SwitchA-Vlan-interface100] quit
[SwitchA] interface Vlan-interface 200
[SwitchA-Vlan-interface200] ripng 1 enable
[SwitchA-Vlan-interface200] quit
# Configure Switch B.
[SwitchB] ripng 1
[SwitchB-ripng-1] quit
[SwitchB] interface Vlan-interface 101
[SwitchB-Vlan-interface101] ripng 1 enable
[SwitchB-Vlan-interface101] quit
[SwitchB] interface Vlan-interface 100
[SwitchB-Vlan-interface100] ripng 1 enable
[SwitchB-Vlan-interface100] quit
Display the routing
information of a
specified RIPng process
display ripng process-id route Available in any view
Display RIPng interface
information
display ripng process-id
interface [ interface-type
interface-number ]
Available in any view
To do... Use the command... Remarks
Vlan-int100
1::2/64
Vlan-int200
3::2/64
Vlan-int200
3::1/64
Vlan-int600
4::1/64
Vlan-int100
1::1/64
Switch A
Switch B
Switch C
RIPng
GE3/1/1
GE3/1/1
GE3/1/2
GE3/1/1