3Com Switch 8800 Advanced Software V5 Configuration Guide

356 CHAPTER 31: IPV6 OSPFV3 CONFIGURATION
Configuring OSPFv3
Basic Functions
Prerequisites ■ Make neighboring nodes accessible with each other at network layer.
■ Enable IPv6 packet forwarding
Configuring OSPFv3
Basic Functions
To configure OSPFv3 basic functions, use the following commands:
n
■ Configure an OSPFv3 process ID when enabling OSPFv3. The process ID takes
effect locally, without affecting packet exchange between routers.
“Configuring OSPFv3 Routing
Information Management” on
page 358
“Configuring OSPFv3 Route
Summarization” on page 358
Optional
“Configuring OSPFv3 Inbound
Route Filtering” on page 358
Optional
“Configuring Link Costs for
OSPFv3 Interfaces” on page 359
Optional
“Configuring the Maximum
Number of OSPFv3
Load-balanced Routes” on page
359
Optional
“Configuring a Priority for
OSPFv3” on page 359
Optional
“Configuring OSPFv3 Route
Redistribution” on page 359
Optional
“Tuning and Optimizing an
OSPFv3 Network” on page 360
“Configuring OSPFv3 Timers”
on page 360
Optional
“Configuring the DR Priority for
an Interface” on page 361
Optional
“Ignoring MTU Check for DD
Packets” on page 361
Optional
“Disable Interfaces from
Sending OSPFv3 Packets” on
page 362
Optional
“Enable the Logging on
Neighbor State Changes” on
page 362
Optional
Task Description
To do... Use the command... Remarks
Enter system view system-view -
Enable OSPFv3 and enter
its view
ospfv3 [ process-id ] Required
Specify a router ID router-id router-id Required
Enter interface view interface interface-type
interface-number
-
Enable OSPFv3 on the
interface
ospfv3 process-id area
area-id [ instance instance-id ]
Required
Not enabled by default