3Com Switch 8800 Advanced Software V5 Configuration Guide

362 CHAPTER 31: IPV6 OSPFV3 CONFIGURATION
Disable Interfaces from
Sending OSPFv3 Packets
To disable interfaces from sending OSPFv3 packets, use the following commands:
n
■ Multiple processes can disable the same interface from sending OSPFv3
packets. Using the silent-interface command disables only the interfaces
associated with the current process rather than interfaces associated with other
processes.
■ After an OSPF interface is set to silent, direct routes of the interface can still be
advertised in Intra-Area-Prefix-LSAs via other interfaces, but other OSPFv3
packets cannot be advertised. Therefore, no neighboring relationship can be
established on the interface. This feature can enhance the adaptability of
OSPFv3 networking.
Enable the Logging on
Neighbor State Changes
To enable the logging on neighbor state changes, use the following commands:
To do... Use the command... Remarks
Enter system view system-view -
Enter OSPFv3 view ospfv3 [ process-id ] -
Disable interfaces
from sending OSPFv3
packets
silent-interface { interface-type
interface-number | all }
Required
Not disabled by default
To do... Use the command... Remarks
Enter system view system-view -
Enter OSPFv3 view ospfv3 [ process-id ] -
Enable the logging
on neighbor state
changes
log-peer-change Required
Enabled by default