3Com Switch 8800 Advanced Software V5 Configuration Guide

42 CHAPTER 3: LOGGING IN TO A SWITCH
3 Dial up to connect to the switch through the terminal emulation program and
Modem at the remote side (the dialed number should be the telephone number of
the Modem connected to the switch), as shown in
Figure 19 and Figure 20.
Figure 19 Set the dialed telephone number
Figure 20 Dial up on a remote computer
4 Enter the login password through the remote terminal emulation program, and
the system displays command line prompt (such as <SW8800>) to configure or
manage the switch. Enter "?" for help at any time, and refer to the corresponding
chapters in this manual for specific commands.
n
By default, Modem users logging in successfully through a Modem can access the
commands at level 0.