3Com Switch 8800 Advanced Software V5 Configuration Guide

Configuring Asynchronous Serial Interface Attributes 45
Configuring
Asynchronous Serial
Interface Attributes
Follow these steps to configure asynchronous attributes of a serial interface:
n
The above configuration takes effect only when the asynchronous serial interface
is working in asynchronous flow mode.
Configuring Terminal
Attributes
“Configuring Access Restriction on VTY User
Interface(s)” on page 48
Optional
“Configuring Supported Protocols on VTY
User Interface(s)” on page 48
Optional
“Configuring Authentication Mode at
Login” on page 49
Optional
“Sending Messages to the Specified User
Interface(s)” on page 50
Optional
“Releasing the Connection Established on
the User Interface(s)” on page 50
Optional
“Displaying and Maintaining User
Interface(s)” on page 50
Optional
Task Remarks
To do... Use the command... Remarks
Enter system view system-view --
Enter user interface view user-interface { first-num1 [
last-num1 ] | { aux | console |
vty } first-num2 [ last-num2 ] }
--
Configure transmission speed speed speed-value Optional
9600 bps by default
Configure flow control mode flow-control { none |
software | hardware }
Optional
none by default
Set parity bits parity { none | even | odd |
mark | space }
Optional
none by default
Set stop bits stopbits { 1.5 | 1 | 2 } Optional
1 by default
Currently, stop bits 1.5 cannot
be configured.
Set data bits databits { 5 | 6 | 7 | 8 } Optional
8 by default
Currently, data bits 5 and 6
cannot be configured.
To do... Use the command... Remarks
Enter system view system-view --
Enter user interface view user-interface { first-num1 [
last-num1 ] | { aux | console |
vty } first-num2 [ last-num2 ] }
--