3Com Switch 8800 Advanced Software V5 Configuration Guide

IPv6 PIM Configuration Examples 697
IPv6 PIM
Configuration
Examples
IPv6 PIM-DM
Configuration Example
Network requirements
■ Receivers receive VOD information through multicast. The receiver groups of
different organizations form stub networks, and one or more receiver hosts
exist in each stub network. The entire IPv6 PIM domain operates in the dense
mode.
■ Host A and Host C are multicast receivers in two stub networks.
■ Switch A connects to the network where the source resides through
VLAN-interface 100, to Switch B through VLAN-interface 101, and to Switch C
through VLAN-interface 102.
■ Switch B and Switch C connect to N1 and N2 through VLAN-interface 200 and
VLAN-interface 300 respectively, and to Switch A through VLAN-interface 101
and VLAN-interface 102 respectively.
View the IPv6 PIM information
on an interface or all
interfaces
display pim ipv6 interface [
interface-type
interface-number ] [ verbose
]
Available in any view
View the information of
joint/prune messages to send
display pim ipv6 join-prune
mode { sm [ flags flag-value ]
| ssm } [ interface
interface-type
interface-number | neighbor
ipv6-neighbor-address ] * [
verbose ]
Available in any view
View IPv6 PIM neighboring
information
display pim ipv6 neighbor [
interface interface-type
interface-number |
ipv6-neighbor-address |
verbose ] *
Available in any view
View the content of the IPv6
PIM routing table
display pim ipv6
routing-table [
ipv6-group-address [
prefix-length ] |
ipv6-source-address [
prefix-length ] |
incoming-interface [
interface-type
interface-number | register ] |
outgoing-interface {
include | exclude | match } {
interface-type
interface-number | register } |
mode mode-type | flags
flag-value | fsm ] *
Available in any view
View the RP information display pim ipv6 rp-info [
ipv6-group-address ]
Available in any view
Reset IPv6 PIM control
message counters
reset pim ipv6
control-message counters [
interface interface-type
interface-number ]
Available in use view
To do... Use the command... Remarks