3Com Switch 8800 Advanced Software V5 Configuration Guide

9
LINK AGGREGATION CONFIGURATION
When performing link aggregation configuration, go to these sections for
information you are interesting in:
■ “Configuring Link Aggregation” on page 77
■ “Displaying and Maintaining Link Aggregation” on page 80
■ “Link Aggregation Configuration Example” on page 80
Configuring Link
Aggregation
c
CAUTION: If an abnormal operating state of a port in a dynamic aggregation
group caused by the existence of an empty aggregation group, you can try the
following steps to correct the error: (a) delete the empty aggregation group; (b)
disable LACP on the port in question, and (c) enable LACP on the port in question
again.
When configuring a link aggregation group, go to these sections for information
you are interested in:
■ “Configuring a Manual Link Aggregation Group” on page 77
■ “Configuring a Static LACP Link Aggregation Group” on page 78
■ “Configuring an Name for a Link Aggregation Group” on page 79
■ “Configuring a Service Loop Group” on page 79
■ “Entering Aggregation Port Group View” on page 80
Configuring a Manual
Link Aggregation Group
Follow these steps to configure a manual aggregation group:
Note that:
■ You may create a manual aggregation group by changing the type of a static or
dynamic aggregation group that has existed. If the specified group contains
To do... Use the command... Remarks
Enter system view system-view --
Create a manual aggregation
group
link-aggregation group
agg-id mode manual
Required
Enter Ethernet interface view interface interface-type
interface-number
--
Assign the Ethernet port to
the aggregation group
port link-aggregation
group agg-id
Required