3Com Switch 8800 Advanced Software V5 Configuration Guide

IPv6-Based VRRP Configuration Example 787
# Set the authentication mode for standby group 1 to SIMPLE and authentication
key to hello.
[SysnameA-Vlan-interface2] vrrp ipv6 vrid 1 authentication-mode simple hello
# Set the VRRP advertisement interval to 500 centiseconds.
[SysnameA-Vlan-interface2] vrrp ipv6 vrid 1 timer advertise 500
# Set Switch A work in preemption mode. The preemption delay is five seconds.
[SysnameA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
# Set the interface to be tracked.
[SysnameA-Vlan-interface2] vrrp ipv6 vrid 1 track interface vlan-int
erface 3 reduced 30
[SysnameA-Vlan-interface2] return
2 Configure Switch B
# Configure VLAN 2.
<SysnameB> system-view
[SysnameB] ipv6
[SysnameB] vlan 2
[SysnameB-vlan2] port ethernet 1/5
[SysnameB-vlan2] quit
[SysnameB] interface vlan-interface 2
[SysnameB-Vlan-interface2] ipv6 address fe80::2 link-local
[SysnameB-Vlan-interface2] ipv6 address 1::2 64
# Create a standby group 1 and set its virtual IP address to FE80::10.
[SysnameB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Set the authentication mode for standby group 1 to SIMPLE and authentication
key to hello.
[SysnameB-Vlan-interface2] vrrp ipv6 vrid 1 authentication-mode simple hello
# Set the VRRP advertisement interval to 500 centiseconds.
[SysnameB-Vlan-interface2] vrrp ipv6 vrid 1 timer advertise 500
# Set Switch B to work in preemption mode. The preemption delay is five seconds.
[SysnameB-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
3 Verify the configuration
After the configuration, Host B can be pinged through on Host A. You can use the
display vrrp ipv6 command to verify the configuration.
# Display detailed information of standby group 1 on Switch A.
<SysnameA> display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 500
Admin Status : UP State : Master