3Com Switch 8800 Advanced Software V5 Configuration Guide

866 CHAPTER 67: VLAN POLICY CONFIGURATION
Applying VLAN Policy
Configuration
Prerequisites
■ The VLAN poly to be applied is defined. Refer to “Configuring QoS Policy” on
page 840 “Configuring QoS Policy” on page 840 for details.
■ VLANs where the VLAN policy is to be applied is specified.
Configuration Procedure Follow these steps to apply the VLAN policy to the specific VLAN:
Displaying and
Maintaining VLAN
Policy
Follow these steps to display and maintain VLAN policy:
VLAN Policy
Configuration
Examples
Network Requirements ■ The VLAN policy test is defined to perform TP for packets matching ACL 2000,
with the CIR parameter being 8.
■ Apply the VLAN policy to the inbound direction of VLAN 200, VLAN 300, VLAN
400, VLAN 500, VLAN 600, VLAN 700, and VLAN 800.
Configuration Procedure <Sysname> system-view
[Sysname] traffic classifier cl1 operator or
[Sysname-classifier-cl1] if-match acl 2000
[Sysname-classifier-cl1] quit
[Sysname] traffic behavior be1
[Sysname-behavior-be1] car cir 8
[Sysname-behavior-be1] quit
[Sysname] qos policy test
[Sysname-qospolicy-test] classifier cl1 behavior be1
[Sysname-qospolicy-test] quit
[Sysname] qos vlan-policy test vlan 200 300 400 500 600 700 800 inbound
Operation Command Description
Enter system view system-view -
Apply the VLAN policy
to the specific VLAN
qos vlan-policy policy-name vlan
vlan-id-list { inbound | outbound }
Required
To do... Use the command... Remarks
Display the
information about a
VLAN policy
display qos vlan-policy { name
policy-name | vlan vlan-id } [ slot
slot-id ]
Available in user view
Clear the statistics
information about
VLAN policies
applied to a VLAN
reset qos vlan-policy [ vlan
vlan-id ]