MSM710 Controllers Installation Guide v5.7.0

3. On the Configure guest authentication page, select the Use the user account feature on the
controller option, then set both Username and Password to guest1. Leave all other options at
their defaults, then select Next.
4. On the Guest DHCP addressing page, select DHCP server.
a. Define the DHCP server IP address range:
• Set Start address to 192.168.1.1
• Set End address to 192.168.1.254
• Set Netmask to 255.255.255.0
NOTE: The first address in the range is reserved for the controller gateway and DNS
(192.168.1.1 in this example). The DHCP server assigns addresses to clients at Start
address +1, (192.168.1.2 in this example).
b. Select Next.
12 Controller initial configuration