760wl 2004-03

Chapter 2– Hardware Installation

This chapter describes the installation of the HP ProCurve Access Control Server 740wl, and Access

Controller 720wl.

Chapter 3– Network Setup

This chapter describes the network configuration of the Access Control Server after it has been physically

installed.

Chapter 4–Basic Configuration

This chapter leads you through the configuration of a basic system setup that provides user accounts and

user authentication, as well as a PPTP gateway, and supports an external authentication service such as

LDAP.

Appendix A–Troubleshooting

This chapter presents troubleshooting procedures for the 700wl Series system.

Appendix C–LCD Display Description

This appendix describes the LCD display on the Access Controller 720wl, Access Control Server 740wl,

and Integrated Access Manager 760wl. The display can be used to view the system’s network parameters,

and to power down the system.

Appendix D–Technical Specifications, Safety and Compliance

This appendix describes the technical specifications of the system, and provides safety and compliance

information.

Appendix E–Cable and Connector Specifications

This appendix describes the Serial Connector and the Standard Ethernet cables for use with the 700wl

Series system.

Related Publications

The following lists related publications:

• HP ProCurve Secure Access 700wl Series Management and Configuration Guide, Software Release 4.0

• HP ProCurve 700wl Series Release Notes

• HP ProCurve 700wl Series Quick Start Guides

viii HP ProCurve Secure Access 700wl Series Installation and Getting Started Guide