760wl 2004-03

Introduction to the HP ProCurve 700wl Series

Integrated Access Manager Only

If you are installing an Integrated Access Manager 760wl only, perform installation in the following order:

Step 1. Install the Integrated Access Manager, following the steps in the HP ProCurve 700wl Series Quick

Start Guide included in the Documentation Kit that came with the unit, or in Chapter 2,

“Hardware Installation” in this manual.

Step 2. Perform the network setup for the Integrated Access Manager and its internal Access Controller,

following the steps in —Access Control Server or Integrated Access Manager Setup“ on page 3-2.

Integrated Access Manager With Additional Access Controllers

If you are installing an Integrated Access Manager 760wl with one or more Access Controllers, perform

installation in the following order:

Step 1. Install the Integrated Access Manager, following the steps in the HP ProCurve 700wl Series Quick

Start Guide included in the Documentation Kit that came with the unit, or in

Chapter 2,

“Hardware Installation” in this manual.

Step 2. Perform the network setup for the Integrated Access Manager and its internal Access Controller,

following the steps in —Access Control Server or Integrated Access Manager Setup“ on page 3-2.

Step 3. Install the additional Access Controllers following the steps in the HP ProCurve 700wl Series

Quick Start Guide, or in Chapter 2, “Hardware Installation” in this manual.

Step 4. Once each Access Controller is recognized by the Integrated Access Manager and appears in the

Integrated Access Manager Administrative Console, perform any additional setup required,

following the steps in

“Completing the Installation” on page 3-18.

Redundant Access Control Servers with One or More Access

Controllers

Step 1. Install each Access Control Server, following the steps in the HP ProCurve 700wl Series Quick Start

Guide included in the Documentation Kit that came with the unit, or in

Chapter 2, “Hardware

Installation” in this manual.

Step 2. Perform the network setup for each Access Control Server, following the steps in“Access Control

Server or Integrated Access Manager Setup” on page 3-2.

Note the IP address and shared secret of the Access Control Server that you plan to designate as

the Primary Access Control Server. Do not configure the Access Control Servers (yet) as

redundant peers.

Step 3. Install the Access Controllers following the steps in the HP ProCurve 700wl Series Quick Start

Guide, or in Chapter 2, “Hardware Installation” in this manual.

Configure the Access Controllers with the IP address and shared secret of the Primary Access

Control Server.

Step 4. Once the Access Controller is recognized by the Primary Access Control Server and appears in

the Access Control Server Administrative Console, perform any additional setup required,

following the steps in

“Completing the Installation” on page 3-18.

Step 5. On the Access Control Server that is to be the redundant (non-Primary) Access Control Server, set

the shared secret to be the same as the Primary Access Control Server.

HP ProCurve Secure Access 700wl Series Installation and Getting Started Guide 1-3