760wl 2004-03

Network Setup

Figure 3-7. Network Setup page for an Access Control Server

Step 6.

If appropriate, enter a fully-qualified hostname for this Access Control Server.

Step 7. Enter the name of the domain in which this Access Control Server resides.

Step 8. If you choose to use DHCP to obtain an IP address for this unit, leave the Configure field set to

Using DHCP, then enter any necessary values not supplied by the DHCP server in the appropriate

fields on this page. If your DHCP server is configured appropriately, the IP address, subnet mask

(netmask), gateway, and primary and secondary DNS addresses will already be filled in.

When using DHCP, you cannot change the IP address, subnet mask, or Gateway (default router)

setting. You can change the DNS and WINS server IP addresses, if necessary.

Step 9. If you want to set a static IP address, select Manually from the drop-down list of options for the

Configure field, then enter the IP address, subnet mask, default router address, primary and

secondary DNS server and primary and secondary WINS server IP addresses, as appropriate, in

the fields on this page.

Step 10. Click Save.

HP ProCurve Secure Access 700wl Series Installation and Getting Started Guide 3-11