Installation and Getting Started Guide for 720wl/740wl/760wl 2004-03

Network Setup
<slot> is the slot in which the option card is installed, <port> is the port number. The port is
always port 1 for a single-port card.
If the Access Control Server does not get its IP address through DHCP, set the IP address.
set ip <ip-address> [netmask]
reboot
Step 6.
With the serial console still connected, enter the command:
show ip
and verify that the information displayed is correct.
Step 7. You can now disconnect the serial console.
Step 8. Complete the installation as described in the next section, “Completing the Installation”.
Completing the Installation
You can complete the configuration of your Access Controller through the Administrative Console
running on the Access Control Server or Integrated Access Manager to which the Access Controller is
associated.
Note: Beyond the basic setup, all Access Controller configuration must be done through the Access
Control Server Administrative Console. There is no browser-based Administrative Console provided on
an Access Controller.
If you have configured the Access Controller offline (while disconnected from the network) you must first
connect the unit to your network using the Network Uplink port and a standard 10Base-T/100Base-
TX/1000Base-T Ethernet cable.
Figure 3-11 illustrates both the network uplink connection (via the default
Network Uplink port) and the connection of a wireless Access Point to a downlink port.
Figure 3-11. Network uplink and wireless access point connections on an Access Controller.
1
SLOT
2
2 4
ON
HDD
SCROLL
SELECT
NETWORK
UPLINK
SLOT
3
SLOT
1
RESERVED
hp procurve
J8155A
integrated access manager 760wl
@ab]qhp
Pk Japskng
-,+-,,+-,,, >]oa)P
Opn]ecdp)pdnkqcd
Apdanjap ?]^ha
=__aoo Lkejp
Japskng
Qlhejg
3
Qoan
If the system was configured to obtain an IP address from a DHCP server, then it should obtain one
within 10-20 seconds after connecting to the IP network.
3-18 HP ProCurve Secure Access 700wl Series Installation and Getting Started Guide