Installation and Getting Started Guide for 720wl/740wl/760wl 2004-03

Network Setup
Figure 3-14. Network Setup page
c.
From the System Components List under in the left panel (under the Network Setup
heading) select the Access Controller you just installed to display its
Basic Setup page.
d. Verify that the information for the Access Controller is correct, or enter additional settings as
necessary. From the
Advanced Settings sub-tab you can configure Bridging, IP broadcast
forwarding, and client polling; from the
HTTP Proxy sub-tab you can configure the address
of a proxy server for HTTP requests.
e. Click Save to save any changes you have made to any of the sub-tabs on this page.
f. Click the Date & Time tab to display the Date & Time page, then again select the Access
Controller from the System Components List.
g. To set the time zone, select the appropriate setting from the drop-down list.
h. To configure an NTP server, click the Set time using network time server checkbox, and type
the IP address of a primary and (optionally) a secondary NTP server.
i. Click Save.
HP ProCurve Secure Access 700wl Series Installation and Getting Started Guide 3-21