Installation and Getting Started Guide for 720wl/740wl/760wl 2004-03

P
PPG
GE
EFFRQQ
Basic Configuration
Note: Your RADIUS server must be configured to recognize the Access Control Server as a RADIUS
client.
To configure the Rights Manager to use a RADIUS server for authentication, do the following:
Step 1. From your management station, point your browser to the IP address or hostname of your Access
Control Server or Integrated Access Manager, and logon to the Administrative Console.
The initial page of the Administrative Console appears.
EFRQStep 2. Click the PG
GE
FRQ icon ( ) to go to the Rights Manager.
R
Step 3. Click the Authentication Policies tab to go to the Authentication Policies page (see Figure 4-11).
Figure 4-11. Authentication Policies page
Step 4.
Click the Authentication Services link in the left panel of the page.
The Authentication Services page appears.
Step 5. Click New Service ….
The New Authentication Service — LDAP page appears.
Step 6. Click the RADIUS link in the left pane of the page.
The New Authentication Service — RADIUS page appears, as shown in Figure 4-12.
4-12 HP ProCurve Secure Access 700wl Series Installation and Getting Started Guide