Quick Start Guide for Option Cards - 2003-07

HP PROCURVE SECURE ACCESS 700WL SERIES OPTION CARD QUICK START GUIDE
INSTALLING THE OPTION CARD
1. Be sure that all cables have been removed, and attach a properly grounded ESD wrist strap to your wrist.
2. Remove eight screws that secure the top cover to the chassis, and remove the cover.
3. Insert a #2 Phillips-head screwdriver through the appropriate hole on the option card retaining screw
cover, remove the screw holding the option card cover plate and remove the option card cover plate
from the front of the unit.
4. Remove the option card from its protective packaging, taking care not to damage it.
5. Insert the card into the chassis as shown in Figure 3.
3
4
1
2
/
O
O
N
HDD
SCR
O
LL
S
EL
E
C
T
N
ETW
O
R
K
UP
L
IN
K
RE
S
E
RV
ED
J81
53A
h
p
p
ro
c
u
rve
a
c
c
e
s
s
c
o
n
t
rolle
r
7
2
0
w
l
Option Card
Retaining Screw
Cover
Riser Board
Figure 3: Adding a card
l
6. Be sure that the option card seats firmly.
7. Using the screw removed in Step 3, secure the option card to the chassis by inserting the screw and
screwdriver through the option card retaining screw cover.
8. Make sure the riser board is still perpendicular to the motherboard, and the option card is seated
properly in and perpendicular to the riser board.
9. Replace the cover, making sure the cover clips secure the riser board, and reinstall the eight screws
holding the cover to the chassis.
10. Reconnect the power cable.
YOUR NEW CARD IS NOW INSTALLED CORRECTLY.
LC-to-SC media converter for the HP ProCurve 1 Port Gigabit-SX option card: To connect an SC cable to
this option card, use the LC-to-SC media converter shipped with the card. Make sure you remove the
protective covers on the cable connectors before attempting to insert the connector into the card port, and
before attempting to connect a cable to the female side of the media converter.
If you need help with the installation of this card, see the HP ProCurve SecureAccess 700wl SeriesInstallation Guide .
Hewlett-Packard Company
8000 Foothills Boulevard
Roseville, CA 95747-5552
http://www.hp.com/go/hpprocurve
CAUTION: Blank option card cover plates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents
inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other equipment; and they direct the flow of cooling air through the
chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Safety information for HP ProCurve Fiber Gigabit Ethernet Option Cards
• Complies with CFR Chapter 1, Subchapter J, Part 1040.10. • IEC 60825-1: 1993,
A1: 1997, A2: 2001; IEC 60825-2: 2000
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein and in the Installation Guide may result in
hazardous radiation exposure.
HP Part Number: 5990-5990
Edition 1, July 2003