Quick Configuration Guide for A7000 dl 8xT1/E1 Wide Module 2005-04

10 www.procurve.com 5991-2118
Branch Office 1 Router
(config-rip)#network 10.10.10.0 255.255.255.0 (for eth 0/1)
(config-rip)#network 68.168.72.0 255.255.255.0 (for PPP 1)
Branch Office 2 Router
(config-rip)#network 10.10.30.0 255.255.255.0 (for eth 0/1)
(config-rip)#network 68.168.72.4 255.255.255.252 (for PPP 1)
4. Enter exit to return to the Global Configuration mode.
1. Verify that the prompt of your unit displays (config)#.
2. Enter enable password word
to set the Enable Security mode password.
or
3. Enter enable password md5 word
to encrypt the enable password using MD5 encryption.
The following steps show how to access the Telnet configuration parameters and change the
password. For this example, replace the underlined word
with a password of your choosing. The
ProCurve Secure Router supports five Telnet sessions (0 through 4).
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet session. Your
prompt should now display (config-telnet-0-4)#.
3. Enter password word
to change the login password for the Telnet session.
4. Enter exit to return to the Global Configuration mode.
1. Verify that the prompt of your unit displays (config)#.
2. Enter exit to leave configuration mode.
3. Enter copy running-config startup-config to save the current configuration to memory.
This command may be abbreviated as copy run start.
4. Enter exit to close the configuration session.
Set Enable Security Mode Password
Note
The Enable Security mode passwords are case sensitive.
Configure Telnet Access
Note
An Enable Security mode password and the Ethernet port parameters must be
defined before configured Telnet sessions are activated. Refer to Configure the
Ethernet Port Parameters on page 3 and Set Enable Security Mode Password on
page 10 for more information.
Save the Configuration