Specifications

4-1

Replacing Components

Replacing the Fan Tray

Replacing Components

This chapter shows you how to remove and install the following components:

■ Fan tray (see page 4-1)

■ Power Supplies (see page 4-3)

Caution The HP ProCurve 6600 Switch and its components are sensitive to static

discharge. Use an antistatic wrist strap and observe all static precautions

when replacing components.

Replacing the Fan Tray

When a fan fails, the Fan Status LED on the switch chassis blinks

simultaneously with the Fault LED. The entire fan tray assembly must then be

replaced. You cannot replace individual fans.

Note Although the fan tray assembly is hot swappable, HP ProCurve recommends

that you perform the operation after powering down the switch. If you remove

the fan tray while a switch is running, you have only three minutes to remove

and replace the fan tray before the switch powers down the ports.

To re-enable the ports, you must reset the switch either by pressing the Reset

button or powering off and on the switch.

WARNING If you hot-swap out the fan tray assembly, to avoid contact with

spinning fans, pull the assembly out one-inch and allow the fans to

stop rotating (approximately 5 seconds) before pulling it all the way

out.

To replace a fan tray assembly: