Specifications

4-3
Replacing Components
Replacing a Power Supply
Replacing Components
Replacing a Power Supply
If a 6600 switch is configured with redundant power supplies, the switch does
not suffer loss of traffic or performance if a power supply fails. You should
replace the failed component as soon as possible. The PS (Power Supply) LED
blinks simultaneously with the Fault LED to indicate that a power supply has
failed.
To remove an AC power supply:
1. Ensure the failed power supply is not plugged into an AC power source.
2. Grasping the handle of the failed power supply release the locking
mechanism by squeezing the latch handle and remove the failed power
supply.
3. Insert the new power supply. Slide it in all the way in until the locking
mechanism locks.
Latch release
handle
Power supply
handle