Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-43
Rebooting the Hub
Use the Reboot Hub command under the Main Menu to reset
the agent and all devices managed by the agent. The hardware
configuration for the agent and system tests are displayed on
the VT-100 console, similar to the messages shown in the
following example.
SYSTEM CONFIGURATION:
---------------------
EPROM size: 128KB (configured)
Flash ROM size: 512KB
EEPROM size: 8KB
DRAM size: 4MB
Input FIFO: 1024 bytes
Output FIFO: 1024 bytes
SYSTEM TESTS:
-------------
Console I/O test...
!"#$%&’()*+,-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ
[\]^_‘abcdefghijklmnopqrstuvwxyz{|}~
Flash ROM test...
Checksum test passed
EEPROM header test...
Checksum test passed
DRAM test...
Address ripple test passed
Walking 0 test passed
Walking 1 test passed
Refresh test passed
Output FIFO testing OK ! SIZE 1024 bytes
Input FIFO testing OK ! SIZE 1024 bytes
SYSTEM TESTS COMPLETED
----------------------
Figure 4.35 Screen Messages for Rebooting the Hub
Exiting the VT-100 Console Interface
Use the Exit command under the Main Menu to close the
VT-100 console interface. Note that this command and
<Ctrl+E> have the same effect.