Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-18 Configuring the System
Configuring IPX Trap Receivers
When the hub experiences an unusual event, a message is
issued to all listed network managers. Networks compliant
with Internetwork Packet Exchange (NetWare IPX) protocol
can pass trap messages to IPX Trap Receivers as shown below:
HP J3233A AdvanceStack 100Base-T Hub-12TXM
IPX Trap Receivers
------------------------
Back to Previous Menu
IPX Address Community Name Status
1. 00000000:000000-000000 public DISABLED
2. 00000000:000000-000000 public DISABLED
3. 00000000:000000-000000 public DISABLED
4. 00000000:000000-000000 public DISABLED
5. 00000000:000000-000000 public DISABLED
6. 00000000:000000-000000 public DISABLED
7. 00000000:000000-000000 public DISABLED
8. 00000000:000000-000000 public DISABLED
9. 00000000:000000-000000 public DISABLED
10. 00000000:000000-000000 public DISABLED
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.10 IPX Trap Receivers Menu
Menu items are briefly described in the following table.
Field Description
IPX Address IPX address of the trap receiver. (Provide network number and MAC address components.)
Community Name The community string required for trap management access.
Status The status of the current entry can be set to ENABLED or DISABLED.
Table 4.10 IPX Trap Receivers Menu